Replacing The Belt - Titan ProMark 98:2 Série Mode D'emploi

ProMark
8.11

replAcINg The BelT

Before replacing the belt on your unit, make sure
you have performed the Solvent Flush procedure
as illustrated in the 'Spraying' section of this
manual.
DO NOT attempt this repair while the unit is
running.
1. Loosen the bolt (1) on the front of the belt guard. Lift open
the front end of the belt guard (2) so that the front end of
the belt (3) is exposed.
2. Gently lift the front end of the gas engine. This will loosen
the tension on the belt and make it easier to remove.
PINCH HAZARD. Make sure your fingers remain
clear of the gas engine mounting plate.
BURN HAZARD. Make sure the gas engine has
had time to sufficiently cool before touching it.
3. While the gas engine is lifted up, remove the belt from the
front (4) and rear (5) pulleys.
4. Install the new belt:
a. Insert the belt into the fixed section of the belt guard
b. Gently lift the front end of the gas engine.
c. With the front end of the gas engine lifted, loop the
d. Gently set the the gas engine down. The weight of the
Attention
e. Close the belt guard (2) and tighten the belt guard bolt
fIgure 31
6
5
(6). Loop the belt over the rear pulley (5) until the belt
engages the pulley groove.
other end of the belt around the front pulley (4).
gas engine will create tension in the belt and prevent it
from coming off.
Make sure the belt is not pinched or twisted in
any way once you have set the gas engine back
into place.
(1).
2
maintenance
1
3
4
41