Cleaning The Outside Of The Unit; Cleaning The Airless Spray Gun - Titan ProMark 98:2 Série Mode D'emploi

ProMark
7.3

cleANINg The ouTSIDe of The uNIT

Never spray down the unit with high-pressure or
high-pressure steam cleaners.
Do not put the high-pressure hose into solvents.
Attention
Use only a wet cloth to wipe down the outside of
the hose.
Wipe down unit externally with a cloth which has been
immersed in a suitable cleaning agent.
7.4
cleANINg AIrleSS SprAy guN
Clean the spray gun after each use.
i
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the airless spray gun.
INTAke fIlTer IN AIrleSS SprAy guN
1. Pull the bottom of the trigger guard forward so that it
comes loose from the handle assembly.
2. Loosen and remove the handle assembly from the gun
head.
3. Pull the old filter out of the gun head.
4. Slide the new filter, tapered end first, into the gun head.
5. Place the handle seal into the gun head with the flat side
of the seal toward the gun head.
6. Thread the handle assembly into the gun head until
secure.
7. Snap the trigger guard back onto the handle assembly.
For more detailed information regarding the
i
spray gun(s), refer to the separate spray gun
manual included with the system
cleanup
31