Sae O-Ring Fitting Installation - Titan ProMark 98:2 Série Mode D'emploi

maintenance
fluID SecTIoN cuT-AWAy
fIgure 26
Peaks of upper
packings must
face up.
Torque outlet
valve housing
to 50 ft.-lbs.
(68 Nm).
Use blue
Loctite.
40
8.10
Oil cup area
for piston lube
packing
lubricant.
Peaks of lower
packings must
face down.
Lubricate O-ring.

SAe o-rINg fITTINg INSTAllATIoN

1. Pull washer and o-ring back as far as possible.
2. Lubricate o-ring (1) and entrance port (2).
fIgure 27
3. Screw fitting in until washer pushes o-ring into entrance
and sits flat against port. (Do not tighten! - only do this
step hand tight to compress o-ring into port!)
fIgure 28
4. Back fitting out no more than one complete turn to align
as required.
fIgure 29
5. Torque nut wrench tight holding backup on fitting (3). This
should expose a recess gap (4) behind the nut which can
act as an indicator that the fitting is assembled correctly.
fIgure 30
3
4
Avoid screwing in the fitting too far. This can
cause the washer to bend, which will cause the
O-ring to extrude.
Attention
Avoid leaving the fitting out too far. This can
lead to the O-ring being cut on the threads of the
fitting.
ProMark
1
2