Using the device for the first time
8. Using the device for the fi rst time
Remove the film from the displays and from the loudspeaker on the handset.
8.1. Connecting the base station to the
telephone and electricity networks
Insert the jack plug on the supplied mains adapter S004LV0600045 into
the socket on the rear of the base station.
The socket is labelled with a mains adapter symbol.
Run the cable through the corresponding cable guide.
Plug the mains plug of the mains adapter into a mains socket.
Insert the RJ jack on the supplied telephone cable into the labelled
telephone socket on the rear of the base station.
Run the cable through the cable guide.
Insert the plug on the other end of the telephone cable into the
telephone wall socket.
8.2. Inserting batteries
The handset is supplied with two nickel metal hydride rechargeable batteries
"AAA" 600 mAh.
NOTE!
Only use nickel metal hydride rechargeable batteries of the
supplied type (NiMh; 1.2 V; 600 mAh) in the handset.
The device warranty will expire if you insert any other type of
rechargeable battery. This could damage the handset.
Slide down the battery cover on the back of the handset.
Insert the two rechargeable batteries into the battery compartment,
paying attention to the polarity (+/–) (with the negative end against the
springs).
160 of 190