Maintenance; General - Hatco Intelligent Toast-Qwik ITQ Série Manuel D'installation Et D'utilisation

OPERATION
Updating Software
1. make sure the toaster is plugged into a properly grounded
electrical outlet of the correct voltage, size and plug
configuration.
2. move the power switch located on the back of the toaster
to the "On" position.
• Graphics and software version information will appear
on the display.
3. Touch and hold the
3 seconds to activate the toaster.
4. Touch and hold the POWER SaVE key for 3 seconds (this
can be done during the preheat cycle).
5. Use the left-side
and touch the left-side "5" program key to select.
6. Touch the right-side "1" program key for the password ("6"
key on single conveyor units), and touch the left-side "5"
program key to accept.
7. Insert the designated USB flash drive into the USB port
located above the touchpad control.
8. Touch the left-side "5" program key to start the software
update.
• The software update will begin and last approximately
20 seconds.
NOTICE
Do not remove the flash drive or turn off the toaster during
a software update.
• When the display returns to the main startup screen
showing the company logo and software version
information, the update is complete. It is now safe to
remove the flash drive.

MAINTENANCE

General

Hatco Intelligent Toast-Qwik
for maximum durability and performance with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Put unit in standby, allow to cool, turn OFF power
switch, and unplug power cord before performing
cleaning, adjustments, maintenance, or attempting to
clear a jam.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Do not allow liquids to spill into unit.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
key on the touchpad control for
keys to scroll to Software Update,
Conveyor Toasters are designed
®
Touchpad Control
for single
conveyor unit.
Program
Keys 1–5
Touchpad Control and Display (ITQ-1000-1C shown)
ELECTRIC SHOCK HAzARD: Use only Genuine Hatco
Replacement Parts when service is required. Failure to use
Genuine Hatco Replacement Parts will void all warranties
and may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in
Hatco equipment.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
10
English
Touchpad Display
1 Bun
2 Toast
3 Hash Brown
4 Product 4
5 Product 5
WARNING
Form No. ITQm-0214