Daily Cleaning; Cleaning The Bottom Element Reflector; Cleaning The Fan Filters - Hatco Intelligent Toast-Qwik ITQ Série Manuel D'installation Et D'utilisation

English

Daily Cleaning

To preserve the finish of the toaster, it is recommended that the
metal surfaces be cleaned daily.
WARNING
Submerging or saturating unit with water will damage the
unit and void unit warranty.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
1. Perform the "Daily Shutdown" procedure in the
OPERaTION section, and unplug the power cord.
2. Remove and empty the crumb tray(s) and the toast chute.
a. Wash the crumb tray(s) and the toast chute with warm
water and a mild detergent. Rinse with water.
b. allow the crumb tray(s) and toast chute to air dry.
CAUTION
BURN HAzARD: Do not remove crumb tray for cleaning
until toaster is cool.
3. Wipe the exterior surfaces of the toaster with a non-
abrasive, damp cloth.
• Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner. Hard to reach
areas should be cleaned with a small brush and mild
soap.
4. Clean/polish the product sensor covers and sensor
reflectors using a mild degreaser and a soft, non-abrasive
cloth. NOTICE Do not clean sensor covers or reflectors
with abrasive pads or cleaners.
NOTE: Sensor reflectors are present on dual conveyor units
only.
Product Sensors
Product Sensors and Sensor Reflectors (ITQ-1750-2C shown)
5. Reinstall the crumb tray(s) and toast chute. Refer to the
INSTaLLaTION section for instructions.
Form No. ITQm-0214
Sensor Reflectors Sensor Reflectors

Cleaning the Bottom Element Reflector

The bottom element reflector inside the toasting chamber has
slots that allow bread crumbs to drop through to the crumb tray.
Over an extended period of use, bread crumbs may build up on
the reflector and not drop through onto the tray.
1. Perform the "Daily Shutdown" procedure in the
OPERaTION section, and unplug the power cord.
2. Wipe the crumbs onto the crumb tray using a bristle brush.
• To wipe the reflector, place the bristle brush through the
conveyor belt and wipe to each side.
3. Perform the "Daily Cleaning" procedure in this section.

Cleaning the Fan Filters

Two cooling fan filters are located on
the bottom of the unit. These filters
should be checked/cleaned monthly
or anytime the Warning Light comes
on. Use the following procedure to
clean the filters.
1. Perform the "Daily Shutdown"
procedure in the OPERaTION section, and unplug the
power cord.
2. Slide the filter out of each filter housing on the bottom of the
unit.
5. Rinse the filters using hot water. allow the filters to dry
completely.
4. Slide the filters back into the filter housings. make sure
each filter slides above the filter supports on each side of
the housings.
Filter
Filter
Housing
Removing/Installing the Filters
11
MAINTENANCE
Warning Warning
Light Light
Filter
Support