Maintenance; General; Daily Cleaning - Hatco KRAMPOUZ KGRDG Série Manuel D'installation Et D'utilisation

MAINTENANCE

General

Gas Griddles are designed for maximum durability and
performance with minimum maintenance.
WARNING
Improper installation, operation, or maintenance of this
equipment may result in property damage, serious injury,
or death. Do not operate or service this equipment before
reading and understanding the contents of this manual!
Turn Temperature Controls to OFF position, close gas
shut-off valve, and allow unit to cool before performing
any cleaning, adjustments, or maintenance.
FIRE OR EXPLOSION HAZARD:
• Inspect moveable gas connector regularly. Replace
immediately if any signs of wear are present.
• Verify moveable gas connector has not exceeded its
expiration date. Replace immediately if expired.
• Do not twist moveable gas connector.
• The unit and its individual gas shut-off valve must be
disconnected and isolated from the gas supply piping
system during any pressure testing of the system at
test pressures in excess of 1/2 psi (3.5 kPa.).
• This unit must be isolated from the gas supply piping
system by closing its individual gas shut-off valve
during any pressure testing of gas supply piping
system at test pressures equal to or less than 1/2 psi
(3.5 kPa).
• If the information in these instructions is not followed
exactly, fire or explosion may result causing property
damage, personal injury, or death
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to explosion
or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
conditions. Genuine Hatco Replacement Parts are
specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that
will allow them to operate safely in Hatco equipment.
Do not steam clean or use excessive water on unit.
This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged or
saturated with water.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
BURN HAZARD: Allow unit to cool before performing any
cleaning, adjustments, or maintenance.
CAUTION
For frame of unit, use non-abrasive cleaners and cloths
only. Abrasive cleaners and cloths could scratch finish of
unit, marring its appearance and making it susceptible to
soil accumulation.
Do not use harsh chemicals such as bleach, cleaners
containing bleach, or oven cleaners to clean this unit.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.

Daily Cleaning

To preserve the finish of the unit as well as maintain performance,
it is recommended that the unit be cleaned daily.
1. Perform the "Shutdown" procedure in the OPERATION
section of this manual.
2. Allow the unit to cool until it is slightly warm.
Use caution and wear protection when cleaning warm
griddle. Drip tray, water, and steam will be hot.
3. Using a rigid spatula, scrape the surface of the griddle to
remove all residual food and liquid, pushing it into the drip
tray.
4. Carefully, empty the drip tray into an appropriate waste bin.
5. Reinstall the drip tray. Refer to the INSTALLATION section
for details.
6. Put cool water or a few ice cubes onto the griddle, and
allow to soak for a few minutes. This will help release
cooked-on residue.
NOTE: Make sure the amount of water or ice cubes used will
not overflow out of the drip tray.
7. Using a rigid spatula, push all liquid into the drip tray.
8. Using the rigid spatula to push an abrasive pad, scrub all
remaining food residue from the griddle.
9. Wipe the griddle using a clean, damp cloth.
10. Apply a small amount of vinegar to the griddle to remove
residual flavors and odors.
11. Empty the drip tray into an appropriate waste bin. Clean
the drip tray, and reinstall onto the unit.
NOTE: Clean the griddle surface as soon as possible after
cooking salty foods. Salt left on the griddle will cause
corrosion.
12. Wipe the frame of the unit thoroughly using a non-abrasive
cloth dampened in warm water only.
13. Dry the frame of the unit using a clean, dry, non-abrasive
cloth.
NOTE: The new, stainless steel griddle surface will have a shiny
appearance. Scratches will appear on the surface after
time, which is normal. Eventually, these scratches will
blend together to give the griddle a brushed, weathered
appearance.
10
English
NOTICE
CAUTION
Form No. KGRDGM-0120