Accessing The Km1 Communication Module With The Rpt Parameterisation Tool Via Vbus.net; Web Interface; Menu - Resol KM1 Manuel

6 Accessing the KM1 Communication module with
the RPT Parameterisation Tool via VBus.net
To use RPT, the VBus access over local network has to be enabled.
In order to activate the VBus access, proceed as follows:
Î In the main menu Device Config, select the submenu Remote Access.
Î On the VBus access over local network tab, in the dropdown menu Local
network access enabled? select Yes.
Î On the Remote access over Internet tab, in the dropdown menu Use
VBus.net for remote access? select Yes.
With a VBus.net account you can easily use RPT in order to parameterise the
controller:
Î In the VBus.net menu My Devices, click on Edit.
Î On the General settings page, tick the option Allow parameterization
using the via address and the RESOL Parameterization Tool (RPT).
Î Enter the Via tag from the VBus.net menu item General settings into the
RPT field URL/IP.
Î Enter the password into the Password field.
Î Click on Connect.
7

Web interface

The web interface is integrated in the KM1 Communication module and can be run
on an Internet browser.
The web interface has the following functions:
• KM1 Communication module – status indication
• KM1 Communication module – configuration

7.1 Menu

The menu column with all main menus and their corresponding sub-menus are
indicated on the left-hand side of the web interface.
Note
The menu structure may change in later firmware versions.
The menu bar at the top of the web interface contains the menu items Home and
Login.
24
In order to use the web interface to its full extent, login is required. In order to log
in, proceed as follows:
Î Click Login on the menu bar.
The Login frame appears. The factory setting for both user name and password is
admin.
Î Enter the user name in the User name input field.
Î Enter the password in the Password input field.
Î Click the Login button.
The message Login successful! appears.