Configuring The Remote Access; Advanced Configuration; Network Configuration - Resol KM1 Manuel

If the automatic update query has been deactivated, you can query for updates
manually.
Î In the main menu Configuration, select the submenu General
Î On the Firmware update tab, click on Query for updates now.
Updates available will be displayed under Firmware update.
8.7 Configuring the remote access
ATTENTION! Third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Do change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
KM1 Communication module is to be accessed via the RESOL RPT Parameterisa-
tion Tool.
For older controller models the RESOL ServiceCenter Software is available!
In order to change the remote access password, proceed as follows:
Î In the main menu Device Config, select the sub-menu Remote Access.
Î On the Access VBus over local network tab, tick the Change password
checkbox.
Î Enter the current password into the Current password input field.
The factory setting for the remote access password is vbus.
Î Enter the new password into the New password input field.
Î Enter the new password into the Repeat new password input field.
Î Click Save configuration.
The message Configuration saved successfully! appears.
28
9 Advanced configuration
9.1 Network configuration
The network configuration determines where the KM1 Communication module
obtains its IP information.
There are 2 different settings possible for the network configuration:
• Dynamic (DHCP): The IP information is automatically assigned to the KM1
Communication module by the DHCP server.
• Static: The user manually assigns date and time information to the KM1 Com-
munication module.
Note
Consult the system administrator before changing the factory settings!
In order to configure the network configuration, proceed as follows:
Î In the main menu Device Config, select the sub-menu Network.
Î In the LAN configuration mode dropdown menu, select the desired value.
Î Click Save configuration.
The message Configuration saved successfully! appears.
The menu item IP Recovery can be used for automatically retrieving a new IP
address for the KM1 Communication module in the case that the previous one is
lost. In order to adjust the automatic IP address configuration, proceed as follows:
Î In the IP Recovery menu item, select Yes .
Î Click Save configuration.
The message Configuration saved successfully! appears.
Î Restart the device.
The KM1 Communication module checks every 15 min if an IP address is assigned.
If no IP address has been found after 3 attempts, the KM1 Communication module
will restart. After the restart, the time begins running from 0 on in Time since last
restart. A restart can take up to 90 s.