Reset Button; Accessing The Km1 Communication Module Over The Internet With The Vbus.net Visualisation Portal - Resol KM1 Manuel

4.2 Reset button

Reset button
The reset button is integrated in the operating control LED. By means of the reset
button, the configuration of the KM1 Communication module can be reset to the
factory settings.
LED flashing codes
Colour Permanent
Orange VBus signal available, no
®
connection to VBus.net.
Green VBus signal and connec-
®
tion to VBus.net available.
Orange / Green
LED off The device is booting.
No mains voltage available.
Flashing Fast flashing
No VBus signal Reset is running.
®
available.
VBus signal and IP
®
address available, no
connection to VBus.net.
The device is booting.
5 Accessing the KM1 Communication module over
the Internet with the VBus.net visualisation portal
In order to access the KM1 Communication module over the VBus.net server, pro-
ceed as follows:
Î Enter VBus.net into the address bar of the browser and click Sign up.
Î Wait for the confirmation e-mail to arrive.
Î Click Add new device.
Î Enter the alphanumeric 8-10-digit code (Access Token, see label).
If you do not have a token label, proceed as follows:
Î Activate VBus.net in the KM1, if necessary.
Î In the main menu Device Config, select the submenu Remote Access.
Î Note down the alphanumeric 8-10-digit code (Access Token) indicated on the
Remote access over Internet tab.
Î Enter VBus.net into the address bar of the browser and click Sign up.
Î Wait for the confirmation e-mail to arrive.
Î Click Add new device.
Î Enter the alphanumeric 8-10-digit code (Access Token)
As soon as the remote access over Internet has been enabled, the KM1 Communi-
cation module checks every 60 min if a connection to the VBus.net server exists. If
VBus.net does not answer, the KM1 Communication module will restart. After the
restart, the time begins running from 0 on in Time since last restart. A restart
can take up to 90 s.
www
23