Indication And Operating Elements; Operating Control Led; Wlan / Reset Button; Configuration For Vbus.net - Resol KM2 Manuel

4 Indication and operating elements

The following elements are featured on / in the housing of the KM2 Communica-
tion module:
 Operating control LED
 LAN connector
 WLAN / reset button

4.1 Operating control LED

Operating control LED

The operating control LED indicates the operating status of the KM2 Communi-
cation module by issuing flashing signals and colours.
LED flashing codes
Colour Permanent
Red VBus signal available, no
®
connection to VBus.net
Green VBus signal and connec-
®
tion to VBus.net available
Red / green
LED off The device is booting
No mains voltage available.


Flashing Fast flashing
No VBus signal available
®
VBus signal and
®
IP address available, no
connection to VBus.net
The device is
booting
4.2

WLAN / reset button

WLAN-LED LAN-LED
The WLAN/reset button can be used for activating or deactivating the WLAN
connection respectively. If the WLAN is activated, the WLAN LED will flash green.
The button can also be used for resetting the device.
By means of the reset, the configuration of the KM2 Communication module can
be reset to the factory settings. In order to reset the device, proceed as follows:
Î Press and hold down the WLAN / reset button for 20 s.
The device will restart and the settings set back to factory settings. This process
may take several minutes.
5 Configuration for VBus.net
In most systems, the KM2 Communication module can be connected to VBus.net
without any configuration. For further information, see chap. 9.2 on page 25!
5.1 Accessing the KM2 Communication module over the Internet
with VBus.net
In order to access the KM2 Communication module over the VBus.net server,
proceed as follows:
Î Note down the alphanumeric 8-10-digit code (Token) indicated on the back of
the housing.
Î Enter VBus.net into the address bar of the browser and click Sign up.
Î Wait for the confirmation e-mail to arrive.
Î Click Add new device.
Î Enter the alphanumeric 8-10-digit code (Token).
Reset-Taster
23