Operation; Buttons; Selecting Channels And Adjusting Values; Slide Switch - Resol DeltaSol MX Mode D'emploi

3

Operation

3.1

Buttons

The device is operated via the 3 buttons next to the
display which have the following functions:
Button 1: scrolling backwards through the menu or
increasing adjustment values
Button 2: scrolling forwards through the menu or
decreasing adjustment values
Button 3: changing to the adjustment mode or
confirming
If an adjustment value is shown on the display, SEt is
displayed. Briefly press button 3 in order to access the
adjustment mode
1
3
2
18
2.4

Selecting channels and adjusting values

Î Select the requested channel using buttons 1 and
2.
Î Briefly press button 3, SEt flashes (adjustment
mode)
Î Adjust the value by pressing buttons 1 and 2
Î Briefly press button 3
SEt permanently appears, the adjusted value is stored.
2.5

Slide switch

By means of the slide switch, an adjustable selection
of relays (see channel MM, page 8) can be switched
on (I) or off (0) manually. When the slide switch is set
to Auto, the adjustments of the channels M1 ... M5
are valid.
Manually OFF = 0 (left)
Manually On = I (right)
Automatic mode = Auto (mid position) – adjust-
ments made in M1 ... M5
Slide switch
3.2

Flashing codes and warning symbols

7.1.1 LED flashing codes
green: everything OK
green flashing: manual mode
red flashing: VBus cable broken or controller
®
not detected
7.1.2 Warning symbols
= no VBus communication
®
= manual mode (see chap. 2.5):
flashing: slide switch in position I
permanent: slide switch in position 0