Installation; Mounting - Resol DeltaSol MX Mode D'emploi

2

Installation

2.1

Mounting

The device must only be located in dry interior
rooms. It is not suitable for installation in hazardous
locations and should be protected against electromag-
netic fields.
The device must additionally be supplied from a dou-
ble pole switch with contact gap of at least 3 mm.
Please pay attention to separate routing of sensor ca-
bles and mains cables.
Î Unscrew the crosshead screw from the cover
and remove the cover
Î Mark the upper fastening point on the wall. Drill
and fasten the enclosed wall plug and screw leav-
ing the head protruding
Î Hang the housing from the upper fastening point
and mark the lower fastening points (centres
180 mm)
Î Drill and insert the lower wall plug
Î Fasten the housing to the wall with the lower fas-
tening screw and tighten
16
crosshead
screw
push buttons
slide switch
cable conduits with strain
relief
cover
lower fastening
WARNING!
upper fastening
180
180
208
Electric shock!
Upon opening the housing, live parts
are exposed!
Î Always disconnect the
device from power supply
before opening the housing!