Figure 17. 240 Vac Or 120 Vac Wiring Diagram; Power Pcb - Zodiac AquaPure EI 1APURE35C Guide D'installation Et D'utilisation

English
Page 14
When using electrical products, basic precautions should always be followed, including the following:
• DANGER: RISK OF ELECTRIC SHOCK WHICH CAN RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation or service, ensure that all power to the device is disconnected/turned off at the circuit
breaker. Connect only to a circuit protected by a ground-fault circuit-interrupter (GFCI).
• Grounding is required. The unit should be installed by a qualified service representative and should be properly
grounded and bonded (See Section 3.5, Bonding).
• To avoid property damage, serious injury or death, never use the chassis backplate of the power pack to ground
any other equipment.
• Install to permit access for servicing.
• Please read all cautions and safety instructions in the Important Safety Instructions section. Before attempting
any electrical wiring, be sure to read and follow safety instructions. Wiring should only be attempted by
a qualified professional.
Use Copper Conductors Only – Rated for 90°C Minimum
CIRCUIT
BREAKER
PANEL
240 VAC or
120 VAC
50/60 Hz
3 wire
Pool Pump

Figure 17. 240 VAC or 120 VAC Wiring Diagram

Zodiac AquaPure
®
WARning
POOL
PUMP
TIMER
12
9 3
6
LINE 1
LINE 2
GROUND
TO EARTH
BONDING
POINT
|
Ei Series APURE35C Installation and Operation Manual
®
RED
TO EI™
BLK
CELL
BLUE
TO FAN
OPTIONAL
CONNECTION
TO AQUALINK® RS
OR PDA
FROM CONTROL PCB
GROUND (CHASSIS)
LOAD 1
WHT
LOAD 2
BLK
TO EARTH
BONDING
POINT
*The Power PCB auto-detects voltage

Power PCB*

Factory Wired for
240 VAC or 120 VAC ~
NOT USED
BLK
RED
NOT USED
GRN
RED
YEL
BLK
RIBBON CABLE
NOT USED
NOT USED
RED
BLK
BLUE
0V
BLK
RED
0V
POS
B
A
Line 2
NEUTRAL
Pump
Line 1
ACT