Figure 10. Water Flow Arrows - Zodiac AquaPure EI 1APURE35C Guide D'installation Et D'utilisation

English
Page 12
8. Drill the feeder holes using the holesaw
provided. Ensure holes are clean and smooth
(see Figure 7).
Figure 7. Drilling Feeder holes
9. Use the pipe spacer as shown if mounting on a
40 mm (1½ in.) pipe (see Figure 8).
Figure 8. Pipe spacer
nOTE The pipe spacer is required for 40 mm (1 ½ in.)
diameter pipe only. The spacer is not required on
50 mm (2 in.) pipe.
10. Verify the gasket is attached to the upper clamp.
The curved side of the gasket must be pointing
down so that it will create a seal with the pipe.
11. Secure the clamps, pipe spacer, and gasket
around the pipe as shown (see Figure 9)
making sure the flow arrows on the clamp
point in the direction of the water flow (see
Figure 10). Make sure the two (2) clips on the
sides of the clamp are snapped into place.
Zodiac AquaPure
®
Feeder Holes
Spacer used for 40mm
(1 1/2 in.) pipe only
|
Ei Series APURE35C Installation and Operation Manual
®
Figure 9. Attaching Cell Clamps
12. Insert the o-ring into the channel on the clamp
and then attach the cell (see Figure 10 and 11).
O-Ring

Figure 10. Water Flow Arrows

The groove must
be on the inlet side
Figure 11. Cell Attached
13. Position the locking ring in proper alignment,
making sure the bump aligns with the top thread
(see Figure 12).
Water Flow