Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Page 24
section 5. Operating instructions
WARning
To avoid property damage, serious injury or death, do
not operate the electrolytic cell without water circulation.
A buildup of flammable gasses which can result in FIRE
OR EXPLOSION.
5.1
Control Panel
Indicates level of chlorine output
production. Each light represents a
20% increment of output production.
Indicates there
is not enough
flow through
the cell
Flow
On/Off
Figure 24. Control Panel on the Power Pack
5.2
Turning Power Pack On/Off (Manually)
To turn the Zodiac AquaPure Ei Series APURE35C
chlorine generating device on or off press the
nOTE Because the power pack is wired to the pump's power
source, the power pack can only be turned on when the
pump is turned on.
5.3
Turning Power Pack On/Off (Using the
Pump's External Timer)
If the power pack is wired to the pump's external timer
and the power to the power pack is on, the power pack
will automatically turn on and off when the pump turns on
and off (see Section 3.4). When the power pack is wired
as such, the only setting that must be set manually is the
chlorine output level (see Section 5.4).
Zodiac
AquaPure
®
Check
salt
level
indicator
Salt
Output
TM
button.
|
Ei Series APURE35C
Installation and Operation Manual
®
5.4
setting the Chlorine Output level
When setting the chlorine output level you must
consider the size of the pool, the amount of use the pool
will be receiving and how hot the weather is. All these
factors weigh greatly on the level of output needed. To
adjust the output level, follow these steps:
1.
Turn the power pack on by pressing the
button.
2.
Press the
output level. The minimum setting is 20% (one
amber light). The output can be adjusted in
increments of 20% up to 100%. If the OUTPUT
button is pressed beyond 100%, the output level
setting will drop back to 20%.
Output setting
20% - one (1) light
40% - two (2) lights
60% - three (3) lights
80% - four (4) lights
100% - five (5) lights
5.5
Connection to an Aqualink
Control system
The Zodiac AquaPure Ei Series APURE35C chlorine
generating device can be connected to an AquaLink RS
or PDA Control System (see Section 3.6). For detailed
instructions for the AquaLink RS or PDA Control
System, see the respective manuals.
5.6
Polarity Reversal
The Zodiac AquaPure Ei Series APURE35C chlorine
generating device is a reversable polarity cell which
means that for every five (5) hours of operation the cell
will switch its polarity to help prevent any build up of
calcium on the cell plates. This is sometimes referred
to as the automated cell cleaning feature. During the
transition between changing its polarity there is a five
(5) minute wait time when the cell will not produce any
chlorine. Once it has changed polarity it will continue to
make chlorine.
button to reach the desired
Amount of time cell will run
Cell will run two (2) min.
every ten (10) min.
Cell will run four (4) min.
every ten (10) min.
Cell will run six (6) min.
every ten (10) min.
Cell will run eight (8) min.
every ten (10) min.
Cell will run non-stop.
®
Rs / PDA
Publicité
Chapitres
Table des Matières
