Section 2. General Description; Introduction; Description; Section 3. Installation Information - Jandy Pro Series ePump + SVRS Manuel D'installation Et D'utilisation

Page 8
ENGLISH

Section 2. General Description

2.1

Introduction

This manual contains information for the proper
installation, operation, and maintenance of Jandy
Pro Series ePump + SVRS (Safety Vacuum Release
System) Series variable-speed pump. Procedures in this
manual must be followed exactly. To obtain additional
copies of this manual, contact Zodiac
Support at 800.822.7933 or visit our website at www.
zodiacpoolsystems.com. For address information, see
the back cover of this manual.
2.2

Description

The ePump + SVRS is a variable-speed pump that can
be run from 1050 RPM to 3450 RPM.
NOTE Some controllers may display speeds lower
than 1050 RPM even though the pump only
operates between 1050 RPM and 3450 RPM.
When connected to the ePump + SVRS controller
(JEP-R), up to eight (8) speed settings may be
programmed and recalled. This allows you to select
the most appropriate speed for your application. Even
more versatile programming is possible when you use a
AquaLink RS controller.
®
Listed/Certified to latest
published edition of
ANSI /ASME
®
or its successor stan-
dard, ANSI/APSP-16
Anti-entrapment
Cover/Grate or Suction
Fitting, Screw-fastened
to Main Drain Sump
Suction Outlet
(Main Drain)
WARNING: Suction check valves and hydrostatic valves should not be used with this pump.
Figure 1. Number of Suction Outlets Per Pump
Jandy
Technical
®
At Least
3 Feet
A112.19.8
®
No Valves between
Tee and Main Drains
Valves OK between
Pump and Tee
|
Pro Series ePump w/SVRS
® ™
Jandy Pro Series ePump + SVRS is designed to meet
the needs of today's more hydraulically demanding
pool equipment. The pump housing, backplate, diffuser,
impeller, and hair and lint pot (filter basket) are all
made from high quality thermoplastic materials. These
materials were chosen for their strength and corrosion
resistance.
The pump is driven by an electric motor directly
attached to the pump impeller. As the electric motor
turns, it causes the impeller to turn, which forces water
to flow through the pump. The water flows through the
pump inlet and then into the filter basket. The basket
assembly pre-strains/traps large particles. The water
then enters the center of the pump housing, flows
through the impeller into the diffuser, and flows out the
pump discharge port.

Section 3. Installation Information

3.1

Plumbing

Preparation Information
1. Upon receipt of the pump, check the carton for
damage. Open the carton and check the pump for
concealed damage, such as cracks, dents or a bent
base. If damage is found, contact the shipper or
distributor where the pump was purchased.
2. Inspect the contents of the carton and verify
that all parts are included. See Section 7.1,
Replacement Parts List and Exploded View.
Listed/Certified to latest
published edition of
ANSI/ASME A112.19.8
or its successor stan-
dard, ANSI/APSP-16
Anti-entrapment
Cover/Grate or Suction
Fitting, Screw-fastened
to Main Drain Sump
Pump
Installation and Operation Manual
Suction Outlet
(Main Drain)