Jandy Pro Series ePump + SVRS Manuel D'installation Et D'utilisation page 4

Page 4
ENGLISH
The SVRS feature on this pump is inactive up to ten (10) minutes after power up. During this period,
the pump does not monitor blocked suction or discharge system condition. Keep bathers out of the pool
when SVRS is not active, such as during the first ten (10) minutes after power up.
To reduce the risk of injury, do not permit children and/or adults not familiar and experienced with the
operation of swimming pool pumps to use this product unless they are closely supervised at all times.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Always disconnect power to
the pump at the circuit breaker and remove the RS-485 communication cable from the pump before
servicing the pump.
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide,
or full flow) valve position with the pump running.
Jandy Pumps are powered by a high-voltage electric motor and must be installed by a licensed or
certified electrician or a qualified swimming pool service technician.
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy Pumps must be installed
in accordance with the National Electrical Code
Occupational Safety and Health Act (OSHA). Copies of the NEC may be ordered from the National Fire
Protection Association, 470 Atlantic Ave., Boston, MA 02210, or from your local government inspection agency.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Never open the drive motor
enclosure. Connect only to a branch circuit that is protected by a ground-fault circuit-interrupter (GFCI).
Contact a qualified electrician if you cannot verify that the circuit is protected by a GFCI. Make sure a
GFCI is be provided by the installer and is tested on a routine basis. To test the GFCI, push the test
button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI
fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump without
the test button being pushed, a ground current is flowing, indicating the possibility of electrical shock.
Do not use the device. Disconnect the device and have the problem corrected by a qualified service
representative before using.
When installed in a location other than single-family dwellings, the National Electrical Code (NEC,
NFPA-70) requires the installation of a clearly labeled Emergency Shutoff Switch, which shall be readily
accessible to the occupants of the pool/spa. Such a switch shall be within sight but at least 5 feet
(1.52m) from the pool or spa.
Incorrectly installed equipment may fail, causing severe injury or property damage.
• Do not connect system to an unregulated city water system or other external source of pressurized
water producing pressures greater than 35 PSI.
• Trapped air in the system can cause the filter lid to be blown off, which can result in death, serious
personal injury, or property damage. Be sure all air is out of the system before operating.
Jandy Pro Series ePump w/SVRS
® ™
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
(NEC ), all local electrical and safety codes, and the
® ®
WARNING
WARNING
WARNING
WARNING
|
Installation and Operation Manual