Cleaning And Storing The Device And Cuff; Error Messages/Troubleshooting - Beurer BM 54 Mode D'emploi

Masquer les pouces Voir aussi pour BM 54:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Step 1: BM 54
Activate Bluetooth
"Preparing the measurement", Bluetooth
Step 2: "beurer Health Manager" app
In the "beurer Health Manager" app, add the
BM 54 under "Settings/My devices".
Step 3: BM 54
take a measurement.
Step 4: BM 54
data transfer immediately fol-
lowing measurements.
• If Bluetooth
data trans-
®
fer has been activated,
data is by transferred after
having confirmed the user
memory by pressing the
pressing the START/STOP
button
.
The "beurer Health Manager" app must be active to allow
data transfer.
on your device (see chapter 4
®
).
®
Step 4: BM 54
Data transfer at a later point:
• Go to memory mode (chap-
ter 7). Select the desired
user memory. The Blue­
tooth
transfer starts auto-
®
matically.
If your smartphone has a protective cover, remove this to ensure
that there is no interference during the transfer. Begin the data
transfer in the "beurer Health Manager" app.

9. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp cloth
only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa-
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects on
the device and cuff. Remove the batteries. The cuff line should
not be bent sharply.

10. Error messages/troubleshooting

In the event of errors, the error message
display.
Error messages may appear if:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
• errors occur during the measurement:
• the pump pressure is higher than 300 mmHg:
• the batteries are almost empty
the data could not be sent via Bluetooth
In such cases, repeat the measurement and/or data transfer.
Ensure that the cuff line is correctly attached and that you do not
move or speak during the measurement.
29
_ appears on the
1;
2;
3;
4;
5;
6;
:
.
®

Publicité

Table des Matières
loading

Table des Matières