Beurer BM 54 Mode D'emploi page 25

Performing the blood pressure measurement
As described above, attach the cuff and adopt the posture
in which you want to perform the measurement.
• Press the START/STOP button
to start the blood pressure monitor.
All display elements are briefly displayed.
The blood pressure monitor will begin the
measurement automatically after 3 seconds.
• You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
displayed.
• The systolic pressure, diastolic pressure
and pulse rate measurements are dis-
played.
• appears if the measurement could not be
performed properly (see chapter 10 "Error
messages/troubleshooting"). Repeat the
measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most recently
used user memory. The relevant
on the display.
.
will be
or symbol appears
25
• Press the START/STOP button
pressure monitor. The measurement is then stored in the
selected user memory.
• If the device is not switched off manually, it will switch
off automatically after 30 seconds.
If Bluetooth ® data transfer is activated, data is transferred
to the "beurer HealthManager" app after confirming the us-
er memory with the START/STOP button
"Transferring measured values").
• The Bluetooth symbol on the display flashes and the
®
blue LED lights up. The blood pressure monitor now at-
tempts to connect to the app for approx. 30 seconds.
• The Bluetooth symbol stops flashing as soon as a con-
®
nection is established. All measurement data is automat-
ically transferred to the app. Once the data has been
successfully transferred, the device switches off. If the
data transfer was unsuccessful, the blue LED goes out
and " " appears on the display.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth
blood pressure monitor switches off automatically after
3 minutes.
Please note that you must add the blood pressure mon-
itor to "My devices" in the "beurer HealthManager" app
to enable data transfer. The "beurer HealthManager"
app must be activated to allow data transfer. If the latest
data is not displayed on your smartphone, repeat the
data transfer as described in chapter 8.
to switch off the blood
(see chapter 8
symbol goes out and the
®