Software Installation - Arexx BS-1000LAN Mode D'emploi

Introduction
The BS1000 is a receiver station for the AREXX Multi Logger system. Like the
BS510 station, the BS1000 receives sensor data via wireless transmission
and sends these data via a USB interface to a PC. The additional Ethernet
link enables the BS1000 to send measured values via a TCP/IP protocol to
one or more PC's in the LAN network or to a remote webserver/website.
This interface allows also the transmission of Messenger e-mails. In addition
to that, the built-in web server can display recent measurement values. With
the latest software it is also possible to synchronize the data of several
BS-1000 or BS-510 receivers.

Software Installation

Prior to using the BS1000 via USB, you have to install the supplied software
on your PC. Insert the supplied CD-ROM into the CD drive of your PC (always
check the latest Software version on our website). After insertion the instal-
lation wizard will appear. If the automatic set up has been disabled in your
Windows software, you can activate the window by opening the Explorer file,
go to the CD drive and double-click on the default.htm file.
Select your language on the installation screen and then select the installa-
tion option. Follow the instructions on the screen.
User manual for the Multilogger-Software
All user information for the Multilogger-Software may be found in the
software's help-section.
Please update regular the multiloggersoftware!
Installation of the receiver
Once you have installed the software and connected the BS1000 to the 7V
power supply, you can connect the receiver module (BS1000) to your com-
puter via the supplied USB lead. Windows will now start installing the
required RF_USB driver. Depending on your Windows version, the installation
process may slightly vary.
Check the "Synchronisation" window in the temperature logger
software. The field is to display the value 'USB@x' and the version
number.
When the installation is complete, click on 'Finish'.
Once the driver has been installed, you can start the application.
You can start the program via the start menu:
Start->All Programs->Temperature-Logger.
On the left side a (still empty) sensor list is displayed. On the right side is a
space for a graphic display of the measured temperature curves. On the left
bottom side of the screen a status bar displays the message 'Ready'.
Use the Help function for more information about the loggersoftware.
SEE: WWW.AREXX.COM
50
E
N
G
L
I
S
H