Arexx BS-1000LAN Mode D'emploi page 55

BS-XXXX communicating to a PC and an external website
This configuration may be used to send Bsxxxx data to a PC in a
network and simultaneously to a Multilogger website.
To setup connection the following steps are required:
1. Follow the section of steps at the first sample installation (in which
the Bsxxxx data are to be sent to a PC in a local network)
2. Open the syncConfig tool in the Multilogger software and select the
menu extra->'generate rulefile for Bsxxxx'. Save this Rulefile at a
E
suitable PC location.
N
3. Proceed by following the steps in the second sample installation (in
which the BSxxxx data are to be sent to a Multilogger website).
G
NOW PAY ATTENTION! Don't upload the rulefile directly to the
BS-xxxx.
L
4. Open the Ruleeditor tool at the Multilogger software
5. In thee Ruleeditor open the file you had created in step 2.
I
6. Select the File->Add menu in the Ruleeditor and select the
Multilogger rulefile you had saved at the PC in step 3.
S
7. Save the assembled Rulefile and upload this file to the BS-xxxx.
H
Uploading may be performed by directly addressing the BS-xxxx or
by selecting menu extra-> upload to Bsxxxx
Wizzard BS1000 Einstellungen Wizard PC Einstellungen
55
Multilogger.nl
Website