Webserver - Arexx BS-1000LAN Mode D'emploi

5. BS-1000 WEBSERVER
The obtained ipaddress and network name with the Networkconfigtool can
be used to get acces to the BS1000 webserver.
Normally, you can use the networkname in the url field of your browser to
access the BS1000. (Please prepend 'http://' before the networkname). If
that is not working, the BS1000 should also be accessible by its ip address.
Fig.7. Webserver BS1000
The embedded Web server contains several pages with recent data. There is
an administrative section available for various settings.
The BS1000 web server can be found at the address given by the network
name.
Make sure that any firewall, antivirus and/or browser
blockades are removed which are applicable to the BS1000.
The BS1000 webserver start page shows for each sensor the most recent
measurement (Fig.7). The value presented is the latest sensor measure-
ment. The time display is formatted according to the default settings on
the computer. The RSSI column gives an indication of the strength of the
received radio signal.
RESET BS1000 Settings and Password
Remove power and inside battery for about 20 sconds.
56
E
N
G
L
I
S
H