Arexx BS-1000LAN Mode D'emploi page 72

APPENDIX
Checking the drivers
- Check (at: Start > Configuration window > Devices and Printers) the
execution of RF-USB. Re-install the driver. Wait to connect the device
until the installation process commands you to do so!
- Check the correct installation of the driver and the PC-connection.
Check the entry 'USB@x' at the "Synchronisation" window of the
Multilogger Software and the accompanying firmware version of the
module. (Multilogger Software Menu – display section: Tools' section)
Checking the sensors
Insert batteries into the sensors. The sensors automatically will register
themselves to the software. Check the "Sensorlist" window at the
Multilogger Software (Multilogger Software Menu – display section: Tools'
section). The sensors' list displays three columns:
Sensor name, Date and Time stamp for the most recent measurement
data and the referenced temperature value.
User manual for the Multilogger-Software
All user information for the Multilogger-Software may be found in the soft-
ware's help-section.
Unknown sensors
You can remove the unknown sensors with the tool
Tool"
RESET BS1000 Settings and Password
Remove power and inside battery for about 20 sconds.
WE ADVICE YOU TO REGULARLY UPDATE THE MULTILOGGER
SOFTWARE VISIT: WWW.AREXX.COM
&
TIPS
72
"Erase Data Flash