Arexx BS-1000LAN Mode D'emploi page 52

3. NETWORKCONFIG TOOL
To program the BS1000 we use the NetworkConfig tool in the Multilogger
software, you can find it in the tools menu. The general settings of the
BS1000 can be inspected and changed by this tool.
- Use DHCP: If this box is checked, the BS1000 will use the network settings of
an available DHCP server. In this case, the other fields below
remain inactive. If this box is not checked, the network settings are
static and the other fields must be filled in.
-Address: the current IP address of the BS1000
-NetMask:
the utilized net mask setting
-Gateway: the utilized Gateway-address
-DNS server: the current DNS-Server
-Network name: the network name of the BS1000
-DNS suffix: the network suffix as indicated by the BS1000.
The Read button asks the BS1000 to supply the parameters.
The Write button writes the parameters into the BS1000.
Direct access with your browser
The BS1000 web server is located at the address defined by the network
name, followed by the DNS network addition. In the example shown above
the BS1000 is located at the address: http://log40 or http://xx.xx.xx
(IP-Adress) The standard network name is 'log', followed by 2 digits. This
name is indicated on the housing of the BS1000. This method allows you to
browse directly to the indicated address without any tools.
52
Screen 1.
NetworkConfig Tool
In this screen you
find the folowing fields:
- Use DHCP:
- Address:
- NetMask:
- Gateway:
- DNS server:
- Network name:
- DNS suffix:
NetWorkConfig tool
E
N
G
L
I
S
H