Multilogger Information - Arexx BS-1000LAN Mode D'emploi

1b. MULTILOGGER INFORMATION
QUICK START
1.1 Starting up
- Please read this manual first.
- Connect the power adapter and switch on the BS1000
E
- The power-on indicator will light up.
- When sensors are active, the receive LED will blink.
N
- Connect the BS1000 receiver to the computer (via USB).
- Start the 'BS1000 NetworkConfig tool' to set up the device It can be
G
found in the tools-menu of the temperature logger software.
L
The latest software is available at
http://www.arexx.com/templogger
I
S
H
1.2 The BS1000 LAN
- The BS1000 receives the measurements from the sensors wirelessly.
- The temperature sensors transmit their data to the BS1000.
- Many sensors (about 60) can be connected to the system at the same time.
- Separate sensors for the Temperature Logger are available at your dealer.
- We have connected 60 sensors to one single receiver without any problems.
- The BS1000 shows the sensor measurements of a longer period of time
graphically on the Internal browser (24 Hours) and multilogger software.
- The range of the sensors can vary as a result of environmental influences.
Depending on the material properties of the surrounding areas, sensors
located inside refrigerator systems may not always be able to communicate
with the receiver.
Depending on the material properties of the surrounding areas, sensors located
inside refrigerator systems may not be able to communicate with the receiver.
The latest software, documentation and manuals see:
http://www.arexx.com/templogger
NetworConfigTool
47