Arexx BS-1000LAN Mode D'emploi page 76

How do we reset the BS-XXX or BS-XXXX?
Switch off the module and remove the internal backup battery for 20 seconds.
If the BS-510 or BS-1000 shortly operate in memory mode, the data
storage does not contain any data, although the yellow LED is fla-
shing?
That is correct. The (permanent) flash memory has been provided with a small
temporary memory, which is not permanent. The temporary memory must be
filled before the contents is transferred to the flash memory. If the module is swit-
ched off before the first data has been transferred to the flash memory, no data
will be stored permanently at all.
After connecting the BS-510 or BS-1000 to the PC, the system does
not transfer any data to the PC?
The logger software will transfer data as soon as the software has succeeded to
connect the PC to the module. If the automatic connection is failing, please check
the following points:
- The logger software has been installed and is working
- The connection to the base station is active: the logger receives new sensor
data.
- The flash memory does contain data.
- The flash memory is working, try to empty the Flash with the tool in the logger
software.
How to remove the memory's contents at the BS-510 or BS-1000 (the
yellow LED is illuminated)
Visit the BS-XXXX 'maintenance' page at the menu section 'administrative
pages'. In this section you will find a button to reset the flash memory. T
his command also checks the functionality of the flash memory.
Use the tool "erase Data Flash Tool" in MENU --> TOOLS in the Logger Software
How can I check the functionality of the internal memory?
We advise to use the flash test at our website. You may also apply the test at the
BS-1000's 'maintenance' page (see the previous FAQ).
76