Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Introduction
The BS1400 is a receiver station for the AREXX Multi Logger system. Like the
BS510 station, the BS1400 receives sensor data via wireless transmission
and sends these data via a USB interface to a PC. The GPRS link enables the
BS1400 to send measured values via GPRS to a remote webserver/website.
This interface allows also the transmission of Messenger e-mails. In addition
to that, the built-in display can show recent measurement values. With the
latest software it is also possible to synchronize the data of several BS-1400
or other Multilogger receivers.
Software Installation
E
Prior to using the BS1400 via USB, you have to install the supplied software
on your PC. Insert the supplied CD-ROM into the CD drive of your PC (always
N
check the latest Software version on our website). After insertion the instal-
lation wizard will appear. If the automatic set up has been disabled in your
G
Windows software, you can activate the window by opening the Explorer file,
go to the CD drive and double-click on the default.htm file.
L
Select your language on the installation screen and then select the installa-
I
tion option. Follow the instructions on the screen.
S
H
User manual for the Multilogger-Software
All user information for the Multilogger-Software may be found in the
software's help-section.
Installation of the receiver
Once you have installed the software and connected the BS1400 to the 7V
power supply, you can connect the receiver module (BS1400) to your com-
puter via the supplied USB lead. Windows will now start installing the
required RF_USB driver. Depending on your Windows version, the installation
process may slightly vary.
Check the "Synchronisation" window in the temperature logger
software. The field is to display the value 'USB@x' and the version
number.
When the installation is complete, click on 'Finish'.
Once the driver has been installed, you can start the application.
You can start the program via the start menu:
Start->All Programs->Temperature-Logger.
On the left side a (still empty) sensor list is displayed. On the right side is a
space for a graphic display of the measured temperature curves. On the left
bottom side of the screen a status bar displays the message 'Ready'.
Use the Help function for more information about the loggersoftware.
Please update regular the multiloggersoftware!
SEE: WWW.AREXX.COM
47
Publicité
Table des Matières
