Arexx BS-1400GPRS Mode D'emploi page 67

What is a logger?
A logger receives sensor data for a given period of time by wireless channels.
Our Multi logger periodically - every 45 seconds - registers e.g. temperature,
humidity, voltages or other parameters and displays these values in a graphical
representation. The considerable number of values allows the system therefore
that a few values may have been missed.
What do we need to build an AREXX Multi logger system?
Three important items are necessary to build a Multi logger system;
- a receiver (BS-XXX, BS-XXXX or e.g. the TL9-ALU)
- One or more sensors (AREXX TSN-, or the PRO-series)
- or 1 or more BS-XX sensor,
- The AREXX logger software
The BS-500 / BS-1000 system does not work?
- start by checking if the Data Receive LED blinks occasionally
- did you correctly plug in, respectively connect the USB-cable?
- did you check and correctly connect the polarity (+ and -) of the external
5 Volt voltage?
- has the driver been installed correctly?
Check the entry 'USB@x' at the "Synchronisation" window of the
Multilogger Software and the accompanying firmware version of the
module. (Multilogger Software Menu – display section: Tools' section)
I have problems with the BS-XX, BS-XXX or BS-XXXX driver
Check the entry of RF-USB in the management for Devices and Printers
(START > CONFIGURATION display > DEVICES & PRINTERS).
Repeat the driver's install procedure; Be careful to connect the device only after a
request by the installation software!
The receiver is listed in the device management, but the sensor list
does not contain any sensor. The Data Receive LED does not blink.
Three possible problems can be the result of this situation:
* The sensors do not transmit any signal
-
* The sensors have not been positioned inside the receiver's range
-
* The receiver does not work properly
-
FAQ AREXX MULTILOGGER
check the batteries (for polarity and voltage)
position the sensor(s) next to the receiver
exchange the receiver for a new one.
67