Airwell PAC BTE UI 4 Manuel D'utilisation page 7

1 - ENERGY DATA SHEETS AND LABELLING
1.1 - DELIVERY CONTROL
Before accepting the delivery you have to check:
that the unit hasn't been damaged during transport.
Check that the materials delivered correspond with that
indicated on the transport document comparing the data
with the identification label 'A' positioned on the packaging.
In case of damage or anomaly:
Write down on the transport document the damage you
found and quote this sentence: "Conditional acceptance
clear evidence of deficiencies/damages during transport".
Contact supplier and the carrier by fax and registered mail
with advice of receipt.
Any disputes must be made within the 8 days following the
delivery. Complaints after this period are invalid.
Internal unit
A
A
A
A identification label
1.2 - STORAGE
Shelter from: direct sunlight, rain, sand and wind.
Stocking temperature:
maximum 50°C
minimum -10°C
The respect of the instructions on the exterior side of the
packaging assures the physical and functional integrity of the
unit for the final user's advantage.
1.3 - HANDLING
The following examples are indications the choice of the
means and of the handling modes will depend on factors.
Verify unit weight and handling equipment lifting capacity .
External unit
A
Identify critical points during handling (disconnected routes,
flights, steps, doors).
Stair climbing trolley.
Use protection (A) to avoid the unit damaging
A
Before handling verify that the unit keeps its balance.
B
C
B Internal unit
C Fork input side the
D Belt input side for lifting by crane
E Maximum inclination
A
A
E
D
7