Airwell PAC BTE UI 4 Manuel D'utilisation page 48

7 - CONTROL
Accessing unit parameters (installer use)
Is possible to choose ALL (the parameters) to access to all the parameters or to choose some subgroups where the parameters are
assembled according to the function.
Only the group of active parameters are visualized, that is relevant to the functions enabled by the unit configuration
1
Select heat pump
Confirm
4
Select All
Confirm
7
Press to go back to the
normal visualization
For the list of parameters see the following pages.
2
Select settings
Confirm
5
Confirm
Select ID7
3
Enter password
Confirm
6
Insert value Confirm
48