Airwell PAC BTE UI 4 Manuel D'utilisation page 65

7 - CONTROL
Circuit 2
Address id Description
4630 Remote controls
4631 Remote supply heat
H2O setpoint
4632 Remote supply cool
H2O setpoint
Remote air temperatu-
4633
re
4634 Remote R.H.
4635 Remote dew tempera-
ture
4636 Flat register
U:M:
Bitmap Bit Function
0 1=ON / 0=OFF
1-6 Free
7 Remote request
8-15 Free
°C*10 Setpoint
°C*10 Setpoint
°C*10 Temperature probe
% Humidity probe
°C*10 Temperature probe
Bitmap Bit Function
0 EnSetAcquaRete
1 EnSondaAriaRete
2 EnSondaUmiditàRete
3 EnStatoRete
4 EnTempRugiada
5 EnChiamataRete
Free
6-15
Enable
EnStatoRete=1 0 = OFF
1 = ON
EnChiamataRete=1 0 = Request from digital input
1 = Request from network
EnSetAcquaRete=1
EnSetAcquaRete=1
EnSondaAriaRete=1
EnSondaUmiditàRete=1
EnTempRugiada=1
Enable
0: Local Enables the network set point,if the
1: Network latter fails it maintainsthe last value
coming from thenetwork
0: Local 0: the ambient thermostatreading
1: Network applies (H1)
1: the networked value applies;if the
latter fails, the thermostatreading
applies
0: Local 0: the thermostat reading applies
1: Network 1: the networked value applies;
if the latter fails, the thermostat
reading applies
0: Local Enables on-off of the circuit
1: network not forceable from remote
0: Local 0: the calculation made by the
1: Network board applies
1: the networked value applies;
if the latter fails, the calculation
made by the board applies
0: Local 0: request from digital inputs
1: request from bit7 of the
1: Network
remote control
Notes
Notes
65