Airwell PAC BTE UI 4 Manuel D'utilisation page 27

5- ELECTRICAL CONNECTIONS
5.6 - EXTERNAL UNIT CONNECTIONS
Carry out the connection in accordance with the electric con-
nection layout.
Remove screws A
Remove the protective cover B
Remove screws A
Remove panel B
A
The indoor and outdoor connecting pipe interface and
power line outlet (C)
Vavious piping and viring patterns can be selected,such as
out from the front ,the back the side ,and undersurface, etc.
(The follow display the locations of several piping and wiring
knock-off interfaces)
A
B
5.7 - ELECTRICAL CONNECTIONS
Power supply 220-240/1/50
A
B
A
C
Front out pipe
Back out pipe
Side out pipe: please remove the L-shape metal plate,
otherwise can not wiring.
Back out pipe:please wipe off the piping support rubber
blanket beside the inner outlet pipe cover of the machine
while back side getting out pipes.
Front out pipe: cut the frontal hole of the pipe-outlet pla-
te.The method of the out pipe in the same way of the back
out pipe.
Undersurface outlet pipe: the knock out should from inside
to outside, and then piping and wiring through this.Pay
attention to the piping the fat connecting pipe should out
from the largest hole, otherwise the pipes will be rubbed.
Please do the moth proofing for the knocked out hole, to
avoid the pest processing into and destroy the compo-
nents.
Side out pipe
Undersurface out pipe
27