Publicité
Les langues disponibles
Les langues disponibles
BM 2610013454 06-10.qxp:BM 2610013454 06-10.qxp 6/1/10 10:36 AM Page 2
Read and understand all
W RNING
instructions. Failure to
follow all instructions listed below may result in
serious personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to
occasionally check the stand and make
sure it is still tight. A loose stand is unstable
and may shift in use and cause serious injury.
Turn tool switch off and disconnect power
before mounting to the stand. Unintended
startup during assembly can cause injury.
You have purchased a Bosch Table Saw
Stand TS2000 or TS3000. Designed for job
site use. This unit sets up and folds quickly,
and is easily loaded or unloaded by one
person into a truck.
TS3000 TABLE SAw STAND
PACkAgE CONTENTS:
Item
Qty.
Part Description
A
(1)
Upper Cross Bar
B
(1)
Lower Cross Bar
C
(1)
Kickback Bar
D
(1)
Right Linkage Bar (R)/
Left Linkage Bar (L)
E
(1)
Right Wheel Assembly (R)/
Left Wheel Assembly (L)
F
(1)
Top Tube Bar
C
Safety Instructions
Before operating make sure the entire unit
is placed on a solid, flat, level surface.
Serious injury could occur if tool is unstable
and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
Pre-Assembly
Phillips screwdriver, 10 MM open end wrench,
16 MM open end wrench, or adjustable
wrench.
Sort out and account for all parts to make sure
that you have all necessary materials to
assemble your stand. Do not discard packing
material until all parts are accounted for.
E
D
E
D
-2-
TOOLS REQUIRED:
BEFORE YOU ASSEMBLE THIS
TABLE SAw STAND:
A
F
B
Publicité
