Power Supply; Installation Location - Medion MD 82294 Mode D'emploi

Power supply

•
The socket outlet must be close to the device and easily accessible. Position the
cable so that it cannot be stepped on or tripped over.
•
To disconnect the power supply from your device, pull the mains adapter from
the socket outlet. Always pull on the mains adapter itself when removing from
the socket outlet. To prevent damage, never pull on the cable.
•
When not in use, pull the mains adapter from the socket outlet, or use a master-
slave power strip to prevent power consumption when switched off.
•
Only operate the mains adapter on earthed socket outlets with 230 V ~ 50 Hz. If
you are not sure about the power supply at the set-up location, please ask your
power supplier.
•
To prevent non-permissible heating up, do not cover the mains adapter.
•
Do not continue to use the mains adapter if the housing or the supply lead to the
device is damaged. Replace it with the same type of mains adapter.
•
Use only the included mains adapter, or one that corresponds to the technical
values (see page 7), otherwise damage might occur.

Installation location

•
In the first few hours of use new appliances can release a typical, unavoidable
but totally safe smell, which reduces with time. To help reduce the amount of
odour build-up, we recommend that you ventilate the room at regular intervals.
We have taken appropriate measures during the development of this product so
that levels are explicitly below legislative limits.
•
Never submerge the transmitter, connection cable or mains adapter in water, as
this poses a risk of electric shock.
•
Never touch the transmitter with wet hands. Operate the transmitter only with
batteries when out of doors. If the mains adapter of the device is connected to
the mains, the device may only be used in dry interior spaces.
•
Do not place vessels filled with liquid, such as vases, on or in the vicinity of the
transmitter and/or mains adapter. The vessel may tip over and the liquid will
impair electrical safety.
•
Protect the transmitter, mains adapter and all connected devices from moisture,
water drops and splashed water.
•
Do not place naked flames, such as lit candles, on or near the device.
•
Do not place any objects on the cable to avoid damaging it.
•
Keep the transmitter and all connected devices away from moisture. Avoid dust,
heat and direct sunshine to prevent breakdowns.
•
Place and operate all components on a stable, level and vibration-free surface to
prevent the loudspeaker from falling down.
•
Ensure an adequate ambient temperature.
4
English