Instructions For Cleaning; Reminders For Cleaning; Instructions For Maintenance; Reminders For The Maintenance Technician - Gastro M 60/30 FRG Serie Installation-Emploi-Entretien

Following prolonged disuse, proceed as follows:
- Inspect the appliance thoroughly before using it
again.
- Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.

INSTRUCTIONS FOR CLEANING

IV.

13. REMINDERS FOR CLEANING

READ THIS MANUAL CAREFULLY. IT
PROVIDES IMPORTANT INFORMATION
FOR SAFE INSTALLATION, USE AND
MAINTENANCE OF THE APPLIANCE.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
- Clean the satin finish stainless steel exterior
surfaces, the cooking wells and the surface of the
hotplates every day.
- At least twice a year, have an authorized technician
clean the internal parts of the appliance.
- Do not use corrosive products to clean the floor
beneath the appliance.
- Do not use direct or high pressure water jets to
clean the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
- Clean the surfaces with a cloth or sponge using
water and proprietary non-abrasive detergents.
Follow the direction of the satin finish lines. Rinse
repeatedly and dry thoroughly.
- Do not use pan scourers or other iron items.
- Do not use chemical products containing chlorine.
- Do not use sharp objects which might scratch and
damage the surfaces.
THE COOKING WELLS
- Clean the wells by bringing the water to the boil,
with the addition of grease remover detergent if
necessary.
- Remove any limescale deposits with a proprietary
limescale remover.
INSTRUCTIONS FOR
V.
MAINTENANCE
14. REMINDERS FOR THE MAINTENANCE
TECHNICIAN
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The
model number is detailed on the packing and
on the appliance dataplate.
The appliance must be installed in a well-
ventilated room.
Do not obstruct any air vents or drains present
on the appliance.
Do not tamper with appliance components.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians authorized by the
manufacturer, in compliance with current
safety standards and the instructions in this
manual.
15. CONVERSION TO ANOTHER TYPE OF
GAS
See Chapter " Instructions for installation ".

16. COMMISSIONING

See Chapter " Instructions for installation ".

17. TROUBLESHOOTING

GAS FRYERS
THE PILOT BURNER DOES NOT LIGHT.
23