Warnings For Operating Interchangeable Equipment; Safety In The Use And Maintenance - Fort VISION Emploi Et Entretien

ENGLISH
WARNING
Keep clean the adhesive signs and replace them
immediately when they are removed or damaged.
Referring to Figure 11, read as described below and
memorize its meaning.
1) The «Auxiliary» label indicates the lever for
auxiliary hydraulic control equipment.
2) Label that indicates the direction of operation of
the lifter.
3) Label that indicates the accelerator content.
4) Label that indicates the lever to set the PTO.
5) Label that indicates the danger of crushinghands.
Pay close attention when folding the roll-bar.
6) Label that indicate that, before you start working
with your machine, you should carefully read the
instructions for use.
7) Label that indicates that before performing any
maintenance work, you should stop the machine,
turn off the engine and read the instruction
manual.
8) Label that indicates the tilting of the machine. Pay
close attention when working on steep slopes.
9) During operation and during maintenance, wear
protective clothing: shoes, glasses, gloves, etc.
10) Noise hazard: during operation, it is recom-
mended the use of protective equipment for
hearing.
11) Label that indicates the sound power emitted by
the machine.
12) The label that indicates the direction of rotation
of the tracks as a function of the position of the
control levers.
13) Risk of sunburn. Do not touch any hot engine
parts.
2.3 WARNINGS FOR OPERATING
INTERCHANGEABLE EQUIPMENT
- Before working on the equipment operated by the
machine: disconnect the power take-off, engage
the parking brake and place the equipment on the
ground, stop the engine, remove the ignition key,
- Attach only suitable equipment to the power of the
tractor in compliance with the standards, marked
«EC» and approved by FORT.
- You cannot go up or down from the tractor when
it is moving, as a special safety system allows the
movement of the machine only when the operator
is in the driver's seat.
- With uneven road, icy or slippery and cornering
surfaces, drive at moderate speed; there may be
reactions of the tractor difficult to control.
- The application of additional equipment to the
tractor involves a different weight distribution.
Therefore, it must not exceed the maximum allowed
load (200 kg).
- With the engine running, it is absolutely forbidden
to remove the guards and intervene in the work
area of the shaft.
- Before attaching, releasing or using the equipment,
you should consult the relevant handbooks. It
remains crucial that before releasing or adjusting
the equipment connected, you need to ground the
same equipment, turn off the engine and engage
the parking brake.
- It is very important to remember that the road
grip and steering/braking may be affected, even
significantly, by the presence of equipment.
- Pay attention when you are in proximity of the
applied equipment; some of them by inertia could
keep the motion even after disconnection from the
PTO or the engine stop.
- Be extremely careful to the correct assembly of
the equipment and follow what is detailed in the
instructions supplied.
- Only use drive shafts marked "CE" and carefully
read their instruction booklet supplied with each
universal joint.
- You may not use unprotected drive shafts.
- It is forbidden to approach the drive shaft during
its rotation. Before leaving the tractor, activate the
parking brake and lay on the ground any equipment.
- Before the lifting, ensure that no persons are in a
dangerous position or in the vicinity of the lifter or
the same organs or tools installed.
- Do not carry passengers on the tractor (in addition
to driver).
- In the work phase, keep the roll-bar in a vertical
position. Lower the roll-bar only when absolutely
necessary and immediately bring it back to the
safety position as soonthe condition of necessity
ceased.
2.4 SAFETY IN THE USE AND
MAINTENANCE
- Always wear suitable clothing. Do not wear loose
clothingas can be caught in moving parts. Long
38
WARNING