Secure (Lock) The Instrument; Powering The Instrument - Tektronix 6 Serie Manuel D'installation Et De Sécurité

Installing your instrument

Secure (lock) the instrument

Lock an instrument to a test bench or equipment rack to prevent property loss.
Attach a standard laptop security lock to the rear panel of the instrument, to secure the instrument to a workbench, rack, or other
location.

Powering the instrument

Use this procedure to connect the instrument to line power and power on and off the instrument. Always connect the instrument
to AC power using the power cord that shipped with the instrument.
Prerequisite: Use the AC power cord that shipped with your instrument.
1. Connect the supplied power cord to the instrument power connector on the back of the instrument.
Figure 1: LPD64 power cord connector and power standby switch
2. Connect the power cord to an appropriate AC mains source.
Power is supplied to the power supply and some other boards whenever the AC power cord is connected to a live mains
circuit, putting the instrument in standby mode.
3. Push the front panel power button to power the instrument on and off.
The power button color indicates instrument power states:
Unlit – no AC power applied
Yellow – standby mode
Blue – powered on
4. To completely remove power from the instrument, disconnect the power cord.
4 LPD64 Installation and Safety Manual