Tektronix 6 Serie Manuel D'installation Et De Sécurité page 15

WARNING. To prevent injury, two people are required to install the instrument.
1. Use two bolts and washers from the supplied hardware to attach one of the rear rack brackets to the rear of the rack.
Tighten by hand.
2. Using two people to support the instrument, insert the instrument from the front of the rack so that the chassis rack bracket
inserts into the rear rack bracket.
3. Continue pushing from the front until the instrument is flush with the front of the rack.
4. Use four bolts and washers from the supplied hardware to attach the front of the instrument to the rack. Tighten by hand to
support the instrument.
5.
From the rear of the rack, slide the second rear rack bracket onto the instrument chassis rack bracket until the rear rack
bracket is flush with the rear rack.
6. Use two bolts and washers from the supplied hardware to attach the second rear rack bracket to the rear of the rack.
Tighten by hand.
7.
Tighten all bolts to 1.1 N·m.
8. Using a 5/16 inch wrench, attach two supplied hexhead bolts to the rack bracket assembly on each side, to lock the
brackets in place and prevent the instrument from unintentional removal when the front rack screws are removed (see the
following image). There are four bolt positions available on each side (see image). Tighten the bracket lock bolts to 0.7 N·m.
9. Attach power cord and cables to rear chassis as needed.
End of rack mount instructions.
LPD64 Installation and Safety Manual
Installing your instrument
3