Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/8/2020 7:48:41 AM
MANUAL INSTALLATION AND OPERATION WFP-75 8411 ENGLISH
OF 40)
7.2
Standards
When installed and operated as described in these instructions, this wood fireplace is suitable
for use in residential installations.
In Canada, the CSA B365 «Installation Code for Solid Fuel Burning Appliances and Equipment»
and the CSA C22.1 «Canadian National Electrical Code» are to be followed in the absence of
local code requirements. In the USA, the ANSI NFPA 211 «Standard for Chimneys, Fireplaces,
Vents and Solid Fuel-Burning Appliances» and the ANSI NFPA 70 «National Electrical Code» are
to be followed in the absence of local code requirements.
This fireplace is not approved for use with a so-called "positive flue connection" to the clay
tile of a masonry chimney.
8. Fireplace Installation
Before installing the fireplace, it is mandatory to install the standoffs on the top,
sides and back of the fireplace.
8.1
Location
The best location for the fireplace should consider the location of windows, doors, and circulation
in the room. There must be enough space in front of the fireplace for the hearth extension and
mantel and on the sides or back for the different heat distribution system, for the fresh air intake
and for the chimney. Ideally, the chimney must be able to pass through the house without the
need to cut floor joists or roof trusses.
8.2
Clearances to combustibles
The clearances shown in this section have been determined by test according to procedures set
out in safety standards ULC S610 (Canada) and UL127 (U.S.A.). When the fireplace is installed
so that its surfaces are at or beyond the minimum clearances specified, combustible surfaces
will not overheat under normal and even abnormal operating conditions.
No part of the fireplace may be located closer to combustibles than the minimum
clearance given.
A material is considered non-combustible when made entirely of steel, iron, bricks, tiles,
concrete, slate, glass or a combination of these materials. Materials corresponding to ASTM
E136 and UL 763 are considered to be non-combustible materials with the exception of
gypsum, which will be considered a non-combustible material only if it is certified to withstand
an ambient temperature of use of 250°F and more.
Page 18
Stove Builder International Inc. | 46345 | Rev: Apr 13 2020 12:33PM | Uncontrolled Copy
WFP-75 8411
Page 707 of 971
(18
Publicité
Chapitres
Table des Matières
