Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/8/2020 7:48:41 AM
MANUAL INSTALLATION AND OPERATION WFP-75 8411 ENGLISH
OF 40)
2. General Information
2.1
Performances
Values are as measured per test method except for maximum heat output.
Models
Fuel Type
Combustion Technology
Maximum heat output (dry cordwood)1
Overall heat output rate (min. to max.)
Average overall efficiency2
Dry cordwood
Optimum efficiency
Average particulate emissions rate
Average CO
8
Specifications
Flue outlet diameter
Type of chimney
Particulate emission standard
USA Standard (Safety)
Canada Standard (Safety)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
1
a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft
and 25%.
2
As measured per CSA B415.1-10 stack loss method.
Higher Heating Value of the fuel.
3
4
Lower Heating Value of the fuel.
5
Optimum overall efficiency at a specific burn rate (LHV).
6
This appliance is officially tested and certified by an independent agency.
7
Tested and certified in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and ASTM E3053
Carbon Monoxide.
8
WFP-75 8411
Stove Builder International Inc. | 46345 | Rev: Apr 13 2020 12:33PM | Uncontrolled Copy
1 2
5
6
WFP-75 8411
Dry Cordwood
Non-Catalytic
80,000 BTU/h (23.4 kW)
14,200 BTU/h to 48,200 BTU/h
(4.16 kW to 14.13 kW)
68 % (HHV)
3
74 %
1.14 g/h (EPA / CSA B415.1-10)
53 g/h
6" (150 mm)
CAN/ULC S629, UL 103 HT
EPA / CSA B415.1-10
7
UL 127
ULC-S610
and 20 lb/ft
3
. The moisture content is between 19%
3
73 % (LHV)
4
7
. Other performances are based on
3
Page 7
(7
Page 696 of 971
Publicité
Chapitres
Table des Matières
