Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
Installation
• Ventilation grills (1), if used, must have openings of at least 200 cm² each.
• The minimum clearance between the minibar's back and the surrounding struc-
ture should be as follows:
No. in
fig. 3, page 4
2
3
• The ventilation duct must at least measure 105 mm x the width of the minibar.
• Only the entire cooling unit must project into the ventilation duct as shown.
• Air passing through the ventilation duct must not be preheated by any source of
heat.
• The ventilation duct must be kept free from any obstacles. Especially portable
multi socket outlets or portable power supplies, which can get warm, must not
be kept at the rear of the minibar.
6.1
Fixing the minibar
➤ Fix the minibar through its fixing feet as shown (fig. 2, page 3).
6.2
Changing the decorative plate
➤ Change the decorative plate as shown (fig. 4 to fig. 7, page 5).
6.3
Mounting the sliding hinge (optional)
You can mount a sliding hinge that allows the minibar door to be opened at the same
time as the door of the built-in cabinet.
➤ Mount the sliding hinge as shown (fig. 8, page 6 to fig. l, page 9).
6.4

Reversing the door

➤ Reverse the door as shown (fig. m, fig. n and fig. q, page 10).
➤ Reverse a door with a sliding hinge as shown (fig. m to fig. q, page 10).
18
Min. distance
20 mm
105 mm
CL460LDC
EN

Publicité

Table des Matières
loading

Table des Matières