Setting The Motor Control - BelFox Ultra VA Mode D'emploi

During gate travel, limbs and fingers can be crushed, crushed or severed
between the gearwheel and the rack!
SAFETY INSTRUCTIONS FOR HAZARD AVOIDANCE
x Do not touch the gearwheel or the toothed rack while the gate is mo-
ving.
x Make sure that children do not touch the gear wheel or the gear rack
while the gate is moving.
x If possible, the gate should only be operated when there is visual
contact with the gate's range of motion.
x
If possible, install an emergency stop command transmitter in order to
be able to trigger an immediate stop in the event of an emergency.

19.2. Setting the motor control

The electrical connection must be made in accordance with the enclosed "47-
21-0" (optional "47-21-i") control instructions.
- The 8-pole rocker switch of the 47-21-0 control unit is used to activate special
functions of the motor control unit. It is not a coding switch for the radio.
- The gate requires a mechanical end stop in the "OPEN" and "CLOSED" end
positions so that the gate cannot run out of the guide in the event of a mal-
function.
WARNING
Risk of injury on the rack
NOTE
27