BelFox Ultra VA Mode D'emploi page 54

1 1 5 5 . . F F u u n n c c t t i i o o n n a a n n d d a a d d j j u u s s t t m m e e n n t t o o f f t t h h e e l l i i m m i i t t s s w w i i t t c c h h e e s s o o n n t t h h e e U U l l t t r r a a
V V A A / / U U l l t t r r a a 8 8 0 0 0 0
As a standard, the sliding gate operators of the Ultra - series are equipped with
contactless magnetic switches, which switch off the gate in its end positions
open/closed. The magnetic limit switches are fixed in the console. The perma-
nent magnets included in the accessory pack are attached to the front of the
rack.
The distance between magnetic switch and magnet must not exceed 10 mm! If
the range of the magnets is not sufficient, a stronger magnet can be used. If the
range of the permanent magnets is not sufficient, a stronger permanent mag-
net can be used or an additional permanent magnet or a distance piece (provi-
ded by customer) must be doubled.
Limit switch
To adjust the magnets, move the door to the desired position. Attach the mag-
nets to the rack opposite the corresponding magnetic switches. By moving the
corresponding magnet you can still adjust the end positions exactly.
The drives are delivered as standard in DIN left (or according to your request)
max. 10 mm
Magnet
Rack
20