Technical Data; Before Starting The Equipment - Scheppach HMS850 Traduction Des Instructions D'origine

6. Technical data

Technical data
Number of knives
Cutter block rpm
Dimensions
Weight
Technical data – Surfacing
Max planing width
Max chip removal
Ripping fence l x h
Ripping fence tilting
angle
Surfacing table size
Technical data – Thicknessing
Max planing width
Max planing thickness
Max chip removal
Thicknessing table size
Drive
Motor V/Hz
Consumption power P1
Subject to technical changes!
Sound
Sound values were measured in accordance with EN
61029.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear ear-muffs.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum!
• Only use appliances which are in perfect working
order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
30 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
2 pieces
8000 1/min
780 x 440 x 455 mm
23 kg
204 mm
2 mm
520 x 102 mm
90°–45°
737 x 210 mm
204 mm
120 mm
2 mm
250 x 204 mm
230V / 50 Hz
1250 W
82 dB(A)
3 dB
93 dB(A)
3 dB

7. Before starting the equipment

Before each use, check the following:
• Proper function of the on and off button, incl. the
emergency switch (if available).
• Locked disconnected protective equipment
(fig 1a - pos. 3) by gradual opening of every sep-
arating protective equipment to be able to turn the
machine off and checking that the machine cannot
be turned on whenever the protective equipment is
open
• Brake Switch on the machine at the start of work
and allow the machine to reach speed. Now switch
the machine off again. The engine must come to a
standstill within 10 seconds. Otherwise, there is a
defect.
• Anti-kick claws (fig. 4 - pos. 25) at least once per
shift by a visual inspection to establish that they
are in good working order, for example, that the
contact surface has not been damaged by impacts
and that the anti-kick claws (25) fall back without
hindrance due to their own weight;
• Planing blades (fig. 13 - pos. 24) for signs of
damage and to ensure they are positioned correct-
ly.
The machine may only be used if all these condi-
tions are satisfied.
Use only well sharpened and maintained blades. Use
only blades that are designed for the machine.
Use pusher wood or sticks which are in perfect con-
dition for machining short workpieces.
Connect the machine to a dust and chip extractor.
Check that the stop is secure before starting the ma-
chining work.
Ensure that you can maintain your balance at all
times. Stand to the side of the machine.
Whilst the machine is running keep your hands at
a safe distance from the cutting block and from the
point at which the chips are discharged.
Do not start the planing work until the cutting block
has reached the required speed.
Also ensure that the workpiece does not contain any
cables, wires, cords or the like. Do not machine any
wood which has lots of knots or knot holes.
Secure long workpieces to prevent them tipping over
at the end of the planing process. Use roller stands,
for example, or similar devices for this purpose.