Kärcher KM 130/300 R D Mode D'emploi page 24

Adjust the side seals
 Check tyre pressure.
 Drive the waste container up and se-
cure it with the safety rod.
DANGER
Risk of injury! Always apply the safety bar
when the waste container is raised.
 Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
1 Holder of safety rod
2 Safety rod
 Open the side cover as described in
Chapter "Replace brush roller".
 Release the 6 wing nuts on the side
holding plate.
 Loosen 3 nuts (SW 13) on the front
holding plate.
 Press the side seal down (elongated hole)
until it is about 1 to 3 mm to the floor.
 Screw in the holding plates.
 Repeat the procedure on the other side
of the appliance.
Check the tyre pressure
 Park the sweeper on an even surface.
 Connect air pressure testing device to
tyre valve.
 Check air pressure and adjust if required.
 For permissible tyre air pressures see
"Technical data".
Manually clean the dust filter
 Clean the dust filter with the filter clean-
ing button.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1 Lock of appliance hood
2 Cover
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.
24
2
1
 Open filter cap.
 Fold the filter vibrator forward.
 Replace the dust filter.
 Close the filter cover.
Check and adjust the V-Belt
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.
 Get the V-belt tension adjusted by an
authorized customer service.
Check air filter and replace, if necessary
 Remove the air filter housing.
 Replace the air filter insert.
9
-
EN
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
Changing the headlight bulb (option)
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.
 Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Replacing fuses
 Open the fuse holder.
 Check the fuses.
Note: The fuse FU 01 is located in the en-
gine compartment.
FU 01 Main fuse
FU 04 Fuel pump
FU 09 Left lighting
FU 10 Right lighting
FU 11 Front work lights (low
beam)
FU 06 Solenoid valve drive
FU 07 Program selection
switch
Waste container func-
tions
FU 08 Safety relay
FU 03 Multifunction display
FU 13 Water pump
FU 05 Time relay
Seat contact switch
FU 02 Horn
Wiper
FU 12 Vibrator system
Beacon lamp
 Replace defective fuses.
Note: Only use fuses with identical safety
ratings.
60 A
10 A
7,5 A
7,5 A
10 A
7,5 A
10 A
7,5 A
3 A
10 A
25 A
7,5 A
20 A