Guide Bar And Saw Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna T435 Manuel D'utilisation

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chain saw model T435. This chain saw model
equipped with either of the listed bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-
2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model Husqvarna T435 met the kickback performance requirements of ANSI B 175.1-2000 when tested with
the combinations of bars and saw chains listed below. The saw chains Husqvarna H36 and H37 are also classified as a
low kickback saw chains since they met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We
recommend to use only the listed combinations of bars and chains for chain saw model Husqvarna T435. Other chain
saw models may not meet the kickback requirements when equipped with the listed bar and chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chain saw model T435. The listed
combination(s) of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards Assosiation
Z62.1-03 (Chain Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H36 and H37 are evaluated and listed as a Type C Low Kickback Saw Chain
according to the provisions in Z62.3-04.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.

Guide bar and saw chain combinations

The following recommended combinations of bar and saw chain are type approved for your chain saw.
Length, inch Pitch, inch
12
14 3/8
16
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
MAINTENANCE
Guide bar
Gauge, inch Max. nose radius
0.050 7 T
Saw chain
Type
45
Husqvarna H36,
52
Husqvarna H37
56
Drive link count