Guide Bar And Saw Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna T540 XP Manuel D'utilisation

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chainsaw model T540XP. This chainsaw model
equipped with either of the listed bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-
2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chainsaw model Husqvarna T540XP met the kickback performance requirements of ANSI B175.1-2000 when tested
with the combinations of bars and saw chains listed below. The saw chain Husqvarna H37 is also classified as a low
kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2000. We
recommend to use only the listed combinations of bars and chains for chainsaw model Husqvarna T540XP. Other
chainsaw models may not meet the kickback requirements when equipped with the listed guide bar and saw chain
combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chainsaw model T540XP. The listed
combination(s) of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards Assosiation
Z62.1-03 (Chain Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H37 is evaluated and listed as a Type C Low Kickback Saw Chain according to
the provisions in Z62.3-04.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.

Guide bar and saw chain combinations

The following recommended combinations of bar and saw chain are type approved for your chain saw.
Length, inch Pitch, inch
12
14 3/8
16
Saw chain filing and file gauges
TECHNICAL DATA
Guide bar
Gauge, inch Max. nose radius
0.050 9T
Saw chain
Type Drive link count
45
Husqvarna H37,
52
Husqvarna H36
56
English – 41