Guide Bar And Saw Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna TrioBrake 135 Mode D'emploi

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chainsaw models 135,135e and 135e TrioBrake.
These chain saw models equipped with either of the listed bar and saw chain combination(s), fulfills the requirements
according to ANSI B175.1-2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw models Husqvarna 135,135e and 135e TrioBrake met the kickback performance requirements of ANSI
B175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H37 is
also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI
B175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna
135,135e and 135e TrioBrake. Other chain saw models may not meet the kickback requirements when equipped with
the listed guide bar and saw chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 135, 135e and 135e
TrioBrake.The listed combination(s) of powerhead, bar and saw chain meet all requirements outlined in Canadian
Standards Assosiation Z62.1-03 (Chain Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H37 is evaluated and listed as a Type C Low Kickback Saw Chain according to
the provisions in Z62.3-04.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
The following cutting attachments are type approved for the models Husqvarna 135, 135e and 135e TrioBrake.

Guide bar and saw chain combinations

The following recommended combinations of bar and saw chain are type approved for your chain saw.
Length, inch Pitch, inch
14
3/8
16
Saw chain filing and file gauges
32 – English
TECHNICAL DATA
Guide bar
Gauge, inch
0.050
Max. nose radius Type
9T Husqvarna H37
Saw chain
Drive link count
52
56
1155296-49 Rev.4 2013-06-20