Key To Symbols; Symbols On The Machine - Husqvarna T435 Manuel D'utilisation

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use can
result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Never let the guide bar tip come in
contact with any object.
Use appropriate protections for foot-leg
and hand-arm.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Recommended cutting
equipment in this example: -
Bar length 12-14 inches - Max.
nose radius 7 Teeth - Chain
type Husqvarna H36/H37
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Chain brake, activated (right)
Chain brake, not activated (left)
2 – English

KEY TO SYMBOLS

Air purge.
Refuelling.
Adjustment of the oil pump.
Chain oil fill.
Working position.
Choke.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.